POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE

INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Note

The regulator arm must be below the intermediate position when installing the power window regulator motor.
1. Apply MP grease to the sliding and rotating areas of the regulator motor.
2. Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.
  
  Torque:
  
  5.4 N*m { 55 kgf*cm, 48 in.*lbf }
  
  Tech Tips
  
  A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Click here
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Click here
INSTALL FRONT DOOR SERVICE HOLE COVER LH

Click here
INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

Click here
INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

Click here
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here
INSTALL ASSIST GRIP COVER LH

Click here
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Click here
INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INITIALIZE POWER WINDOW CONTROL SYSTEM
1. Initialize the power window control system Click here.