POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   
   

   • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

   Click here

3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

   Click here

4. REMOVE ASSIST GRIP COVER LH

   Click here

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

   Click here

7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

   Click here

8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

   Click here

9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

   Click here

10. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

11. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    
    

    1. Using a T25 "TORX" socket wrench, remove the 3 screws and the power window regulator motor.

       

       Text in Illustration

       *1	Spring	-	-
       *a	Range of Movement	-	-

       CAUTION:

       Do not place your finger, etc. within the range of movement of the window regulator. When removing the power window regulator motor, the force of the spring causes the window regulator to move in the direction of the arrow shown in the illustration (the direction in which the window rises), which may cause injury. NOTICE: Be careful when removing the screws as the motor may fall and become damaged.