ROOF HEADLINING(for 3 Door) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE NO. 1 ROOF SILENCER PAD

    B001F2L

    1. w/o Sliding Roof:


      1. Remove the 3 No. 1 roof silencer pads.

    2. B001G1Z

      w/ Sliding Roof:


      1. Remove the No. 1 roof silencer pad.

  2. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)

    B001DBL

    1. Remove the No. 2 roof silencer pad.

  3. REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)

    B001DJC

    1. Remove the No. 4 roof silencer pad.

  4. REMOVE VANITY LIGHT ASSEMBLY LH

    Click here

  5. REMOVE VANITY LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE NO. 1 ROOF WIRE


    1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining assembly.

    2. Detach each clamp and remove the No. 1 roof wire.

    3. Remove any butyl tape remaining on the roof headlining assembly.

      B001EWLC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/ Rain Sensor, for LHD *D w/ EC Mirror
      *E w/ Rain Sensor, for RHD *F w/ Pre-crash Safety System
      *G w/ Pre-crash Safety System, w/ Camera Heater - -
      *a Visor Connector - -

  7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here