ROOF HEADLINING(for 5 Door) REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here

  2. INSTALL NO. 1 ROOF WIRE


    1. Apply butyl tape to the roof headlining so that the tape is aligned with the wire harness marking as shown in the illustration.

      Tech Tips

      Use butyl tape that has a width of 10 mm (0.394 in.).

      A01XHLVE03
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/ Rear Seat Entertainment System - -
      *1 Wire Harness Marking *2 Butyl Tape

    2. Align the No. 1 roof wire with the wire harness installation points as shown in the illustration and attach it to the roof headlining to install it.

      Tech Tips

      Be sure to securely attach the roof wire so that it is not twisted.

    3. Attach each clamp.

      Tech Tips

      Make sure the EC mirror wire harness (w/ EC Mirror) and rain sensor wire harness (w/ Rain Sensor) are securely set into the cutouts of the roof headlining.

    4. Turn the visor connectors approximately 90° clockwise to install them to the roof headlining.

      A01XHEUE02
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/ Rear Seat Entertainment System *D w/ Rain Sensor, for LHD
      *E w/ EC Mirror *F w/ Rain Sensor, for RHD
      *1 Visor Connector *2 Wire Harness Installation Point

  3. INSTALL VANITY LIGHT ASSEMBLY LH


    1. Attach the 3 claws to install the vanity light.

  4. INSTALL VANITY LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)

    B001HI6

    1. Align the No. 4 roof silencer pad with the markings on the roof headlining and install the No. 4 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.

  6. INSTALL NO. 3 ROOF SILENCER PAD

    B001D88

    1. Align the No. 3 roof silencer pad with the markings on the roof headlining and install the No. 3 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.

  7. INSTALL NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)

    B001HXJ

    1. Align the No. 2 roof silencer pad with the markings on the roof headlining and install the No. 2 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.

  8. INSTALL NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)

    B001HNZ

    1. Align the No. 1 roof silencer pad with the markings on the roof headlining and install the No. 1 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.

  9. INSTALL ROOF SIDE AIR OUTLET REGISTER (w/ Rear Air Conditioning System)

    Tech Tips

    Use the same procedure for all roof side air outlet registers.


    1. Attach the 6 claws to install the roof side air outlet register.