ROOF HEADLINING(for 5 Door) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE ROOF SIDE AIR OUTLET REGISTER (w/ Rear Air Conditioning System)

    B001F2W

    Tech Tips

    Use the same procedure for all roof side air outlet registers.


    1. Detach 6 claws and remove the roof side air outlet register.

  2. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)

    B001ILR

    1. Remove the 2 No. 1 roof silencer pads.

  3. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)

    B001ES2

    1. Remove the No. 2 roof silencer pad.

  4. REMOVE NO. 3 ROOF SILENCER PAD

    B001GR5

    1. Remove the No. 3 roof silencer pad.

  5. REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)

    B001CJ1

    1. Remove the No. 4 roof silencer pad.

  6. REMOVE VANITY LIGHT ASSEMBLY LH

    B001CPYC09
    *1 Bulb Holder
    *a Claw A
    *b Claw B

    1. Detach the 2 claws labeled A and separate the bulb holder from the vanity light as shown in the illustration.

    2. Detach the claw labeled B and remove the vanity light assembly LH.

  7. REMOVE VANITY LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. REMOVE NO. 1 ROOF WIRE


    1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining assembly.

    2. Detach each clamp and remove the No. 1 roof wire.

    3. Remove any butyl tape remaining on the roof headlining assembly.

      B001IKHC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/ Rear Seat Entertainment System *D w/ Rain Sensor, for LHD
      *E w/ EC Mirror *F w/ Rain Sensor, for RHD
      *G w/ Pre-crash Safety System *H w/ Pre-crash Safety System, w/ Camera heater
      *a Visor Connector - -

  9. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here