VISCOUS HEATER MAGNET CLUTCH(for 1GD-FTV)

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Cold Area)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

REMOVE UPPER RADIATOR SUPPORT SEAL

REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

DRAIN ENGINE COOLANT

REMOVE NO. 3 ENGINE WIRE (for Cold Area)

REMOVE NO. 1 RADIATOR HOSE

REMOVE NO. 2 INTERCOOLER AIR HOSE

REMOVE NO. 2 RADIATOR HOSE

REMOVE NO. 1 INTERCOOLER AIR HOSE

REMOVE RADIATOR RESERVE TANK ASSEMBLY

DISCONNECT OIL COOLER HOSE (for Automatic Transmission)

REMOVE VISCOUS HEATER V BELT

REMOVE FAN SHROUD

DISCONNECT HEATER WATER OUTLET HOSE

Remove the bolt and disconnect the water hose sub-assembly.
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water outlet hose.
Note
- Do not apply excessive force to the water hose and heater water outlet hose.
- Prepare a drain pan or cloth in case the coolant leaks.

DISCONNECT HEATER WATER INLET HOSE

Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water inlet hose.
Note
- Do not apply excessive force to the water hose and heater water inlet hose.
- Prepare a drain pan or cloth in case the coolant leaks.

REMOVE VISCOUS HEATER WITH MAGNET CLUTCH ASSEMBLY

VISCOUS HEATER MAGNET CLUTCH(for 1GD-FTV) REMOVAL