ROOM TEMPERATURE SENSOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  6. REMOVE COMBINATION METER ASSEMBLY

    Click here

  7. REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)

    A01XEI8

    1. Disconnect the connector and hose.

    2. Detach the 2 claws and remove the cooler thermistor.