CONDENSER FAN INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart.

Click here

PROCEDURE


  1. INSTALL SHROUD BLOWER ASSEMBLY


    1. Install the shroud blower assembly with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Connect the connector.

  2. INSTALL HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY


    1. B001D0HN01

      Install the hood lock support brace sub-assembly with the 4 bolts.

      Torque:
      Bolt A
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Attach the each clamp.

  3. CONNECT OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)

    Click here

  4. INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


    1. Remove the attached vinyl tape from the air conditioning tube and accessory assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler condenser assembly.

      Refrigerant Compressor Oil
      HFC-134a (R134a) ND-OIL 8 or equivalent
      HFO-1234yf (R1234yf) ND-OIL 12 or equivalent

    3. Install the O-ring to the air conditioning tube and accessory assembly.

    4. Attach the clamp to install the air conditioning tube and accessory assembly.

    5. Install the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    6. Connect the connector.

  5. INSTALL HOOD LOCK ASSEMBLY


    1. for LHD:

      Click here

    2. for RHD:

      Click here

  6. INSTALL HOOD LOCK RELEASE LEVER PROTECTOR

    Click here

  7. CHARGE REFRIGERANT


    1. for HFC-134a (R134a):

      Click here

    2. for HFO-1234yf (R1234yf):

      Click here

  8. WARM UP ENGINE


    1. for HFC-134a (R134a):

      Click here

    2. for HFO-1234yf (R1234yf):

      Click here

  9. CHECK FOR REFRIGERANT GAS LEAK


    1. for HFC-134a (R134a):

      Click here

    2. for HFO-1234yf (R1234yf):

      Click here

  10. INSTALL RADIATOR GRILLE

    Click here