CAUTION / NOTICE / HINT
PROCEDURE
INSTALL SHROUD BLOWER ASSEMBLY
Install the shroud blower assembly with the bolt.
Connect the connector.
INSTALL HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY
Install the hood lock support brace sub-assembly with the 4 bolts.
Attach the each clamp.
CONNECT OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)
INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the attached vinyl tape from the air conditioning tube and accessory assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler condenser assembly.
| Refrigerant | Compressor Oil |
|---|---|
| HFC-134a (R134a) | ND-OIL 8 or equivalent |
| HFO-1234yf (R1234yf) | ND-OIL 12 or equivalent |
Install the O-ring to the air conditioning tube and accessory assembly.
Attach the clamp to install the air conditioning tube and accessory assembly.
Install the 2 bolts.
Connect the connector.
INSTALL HOOD LOCK ASSEMBLY
for LHD:
Install the hood lock assembly Click here.
for RHD:
Install the hood lock assembly Click here.
INSTALL HOOD LOCK RELEASE LEVER PROTECTOR
INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
INSTALL RADIATOR GRILLE
CHARGE REFRIGERANT
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
WARM UP ENGINE
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
CHECK FOR REFRIGERANT GAS LEAK
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
INSTALL UPPER RADIATOR SUPPORT SEAL