COMPRESSOR(for 1GD-FTV) DISASSEMBLY

PROCEDURE


  1. REMOVE COOLER BRACKET

    A01XDM1

    1. Detach the clamp.

    2. Remove the screw and the cooler bracket.

  2. REMOVE MAGNET CLUTCH ASSEMBLY

    A01XGFRE07

    1. Clamp the cooler compressor assembly in a vise.

    2. Using SST, hold the magnet clutch hub.

      SST
      09985-00270

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tech Tips

      There is no set number of magnet clutch washers since they are used for adjusting.

    4. A01XE1M

      Using a snap ring expander, remove the snap ring and the magnet clutch rotor.

      Note

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. Disconnect the connector.

    6. A01XL01

      Using a snap ring expander, remove the snap ring and magnet clutch stator.