FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH


    1. B001I58

      Align the claw with the anchor plate positioning hole and install the anchor plate with the 2 bolts.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Tech Tips

      First install the lower bolt, and then install the upper bolt.

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

    A01XCJFE06

    Note

    When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


    1. Align the seat belt retractor positioning holes with the claws of the vehicle.

    2. Install the seat belt with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    3. A01XM7NE03

      Connect the pretensioner connector labeled A as shown in the illustration.

    4. w/ Pre-Crash Safety System:

      Connect the pre-crash safety connector labeled B.

    5. Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Connect the connector.

    2. Attach the 9 claws and 11 clips to install the deck trim side panel.

    3. Install the 3 bolts and 2 screws.

    4. Install the rear No. 1 seat outer belt floor anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    5. Install the front seat outer belt floor anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  5. INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

    Click here

  6. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ o Tonneau Cover)

    Click here

  7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  8. INSTALL REAR FLOOR CARPET ASSEMBLY

    Click here

  9. INSTALL QUARTER TRIM COVER HOLE LH

    Click here

  10. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  11. INSTALL MAT SET PLATE COVER

    Click here

  12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  13. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  14. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  16. CHECK SRS WARNING LIGHT

    Click here