REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH

    A01XHCKE05
    Text in Illustration
    *1 Bolt
    *2 Nut

    Note

    When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


    1. Align the claws with the seat belt positioning holes and install the retractor of the seat belt with the nut and bolt as shown in the illustration.

      Tech Tips

      First install the bolt, and then install the nut.

      Torque:
      for bolt
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
      for nut
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL REAR SEAT SHOULDER BELT GUIDE

    Click here

  3. INSTALL SEATBACK COVER WITH PAD

    Click here

  4. INSTALL REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY

    Click here

  5. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY LH

    Click here

  6. INSTALL REAR SEATBACK COVER

    Click here

  7. INSTALL REAR SEAT SHOULDER BELT COVER

    Click here

  8. INSTALL SEAT BELT ANCHOR COVER CAP

    Click here

  9. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH

    Click here

  10. INSTALL RECLINING ADJUSTER KNOB CAP LH

    Click here

  11. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    A01XLFIE03
    Text in Illustration
    *a Protruding Part

    1. Install the inner belt and connect the 3 point type belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the anchor part of the anchor plate sub-assembly to overlap the protruding parts of the seatback frame.

  12. INSTALL CENTER SEATBACK ASSEMBLY

    Click here

  13. INSTALL SEAT CUSHION COVER WITH PAD

    Click here

  14. INSTALL REAR SEATBACK LOCK STRIKER COVER LH

    Click here

  15. INSTALL REAR SEAT CUSHION MOULDING LH

    Click here

  16. INSTALL CENTER SEAT HINGE COVER RH

    Click here

  17. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  18. INSTALL REAR SEAT UPPER RECLINING COVER LH

    Click here

  19. INSTALL REAR NO. 1 SEAT ASSEMBLY LH


    1. Install the rear No. 1 seat assembly LH Click here.