POWER SEAT CONTROL ECU(for Rear No. 2 Seat) INSTALLATION

CAUTION / NOTICE / HINT

Note


  • If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU Click here.

  • If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU Click here.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FOLD SEAT CONTROL ECU


    1. Install the ECU with the 2 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Connect the 2 connectors.

  2. INSTALL DECK BOARD ASSEMBLY

    Click here

  3. PERFORM INITIALIZATION

    Note


    • If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU Click here.

    • If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU Click here.

  4. CHECK REAR NO. 2 SEAT


    1. Check the power seat operation Click here.