FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH


    1. B001I58

      Align the claw with the anchor plate positioning hole, and install the anchor plate with the 2 bolts.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Tech Tips

      First install the lower bolt, and then install the upper bolt.

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

    A01XCJFE04

    Note

    When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


    1. Align the seat belt retractor positioning holes with the claws of the vehicle.

    2. Install the seat belt with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    3. A01XM7NE02

      Connect the pretensioner connector labeled A as shown in the illustration.

    4. w/ Pre-Crash Safety System:

      Connect the pre-crash safety connector labeled B.

    5. Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL CENTER PILLAR GARNISH LH

    Click here

  4. INSTALL NO. 2 ASSIST GRIP

    Click here

  5. INSTALL NO. 2 ASSIST GRIP PLUG LH

    Click here

  6. INSTALL LOWER CENTER PILLAR GARNISH LH


    1. Attach the 4 claws and 2 clips to install the lower center pillar garnish.

    2. Install the front seat outer belt floor anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  7. INSTALL OUTER LAP BELT ANCHOR COVER

    Click here

  8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  9. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  10. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

  11. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Click here

  12. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  13. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.