FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    1. Partially remove the front door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed Click here.

  4. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Click here

  5. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


    1. Partially remove the rear door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed Click here.

  8. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  9. REMOVE LOWER CENTER PILLAR GARNISH LH


    1. B001DOC

      Remove the bolt and disconnect the front seat outer belt floor anchor.

    2. B001GNR

      Detach the 4 claws and 2 clips and remove the lower center pillar garnish.

  10. REMOVE NO. 2 ASSIST GRIP PLUG LH

    Click here

  11. REMOVE NO. 2 ASSIST GRIP LH

    Click here

  12. REMOVE CENTER PILLAR GARNISH LH

    Click here

  13. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    B001CH6

    1. Remove the nut and shoulder anchor.

    2. A01XKTAE02

      Disconnect the pretensioner connector labeled A as shown in the illustration.

    3. w/ Pre-Crash Safety System:

      Disconnect the pre-crash safety connector labeled B.

    4. A01XF29

      Remove the bolt and seat belt.

  14. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

    B001CZL

    1. Remove the 2 bolts and remove the anchor plate.