FRONT SEATBACK HEATER(for Manual Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT SEATBACK HEATER ASSEMBLY LH

    B001DHME01
    Text in Illustration
    *1 Tack Pin
    *2 Seatback Cover
    *3 Seatback Heater
    *4 Name Stamp

    1. Set the seatback heater with the name stamp side facing the seatback cover.

    2. Install the seatback heater with new tack pins.

  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER


    1. Using hog ring pliers, install the seat cushion cover to the seat cushion pad with new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, avoid wrinkling the cover.

      Tech Tips

      The number of hog rings differs according to seat type.

      B001G24E01
      Text in Illustration
      *A for Type A *B for Type B
      *1 Hog Ring Pliers - -

    2. Attach the 4 claws to install the 2 headrest supports.

    3. B001ENO

      w/ Front Seat Side Airbag:


      1. Connect the seatback cover bracket to the seatback pad.

      2. Install the seatback cover bracket to the seat frame with the nut.

        Torque:
        5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

        Note

        After the seatback trim cover is assembled, make sure the side airbag strap is not twisted.

    4. Close the 2 fasteners, and then close the seatback cover.

      B001GUIE01
      Text in Illustration
      *A for Cloth Seat *B for Leather Seat
    5. B001FURE01
      Text in Illustration
      *1 Hog Ring Pliers

      Using hog ring pliers, install 3 new hog rings.

    6. Connect the seat heater connector and attach the wire harness clamp.

    7. Install the rubber band to the seat cushion spring.

  3. INSTALL FRONT SEAT ASSEMBLY


    1. Install the front seat assembly Click here.