FRONT SEATBACK HEATER(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT SEATBACK HEATER ASSEMBLY LH

    B001DHME01
    Text in Illustration
    *1 Tack Pin
    *2 Seatback Cover
    *3 Seatback Heater
    *4 Name Stamp

    1. Set the seatback heater with the name stamp side facing the seatback cover.

    2. Install the seatback heater with new tack pins.

  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER


    1. B001IEUE01
      Text in Illustration
      *1 Hog Ring Pliers

      Using hog ring pliers, install the seatback cover to the seatback pad with new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, avoid wrinkling the cover.

    2. Attach the 4 claws to install the 2 headrest supports.

    3. w/ Front Seat Side Airbag:


      1. Connect the seatback cover bracket to the seatback pad.

      2. B001ENO

        Install the seatback cover bracket to the seat frame with the nut.

        Torque:
        5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

        Note

        After the seatback trim cover is assembled, make sure the side airbag strap is not twisted.

    4. w/o Seatback board:


      1. Close the 2 fasteners, and then close the seatback cover.

        B001GUIE01
        Text in Illustration
        *A for Cloth Seat *B for Leather Seat
      2. B001FURE01
        Text in Illustration
        *1 Hog Ring Pliers

        Using hog ring pliers, install 3 new hog rings.

      3. Connect the seat heater connector and attach the wire harness clamp.

      4. Install the rubber band to the seat cushion spring.

    5. w/ Seatback Board:


      1. B001HJ7E01
        Text in Illustration
        *1 Hog Ring Pliers

        Using hog ring pliers, install 5 new hog rings.

        Note


        • Be careful not to damage the separate type front seatback cover.

        • Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.

      2. Attach the hooks.

      3. Connect the seat heater connector and attach the wire harness clamp.

  3. INSTALL FRONT SEATBACK BOARD CLIP (w/ Seatback Board)

    Click here

  4. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)

    Click here

  5. INSTALL FRONT SEAT ASSEMBLY


    1. Install the front seat assembly Click here.