FRONT SEAT ASSEMBLY(for Power Seat) DISASSEMBLY

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)


    1. B001DPX

      Detach the 2 hooks and disconnect the 2 rubber bands.

    2. B001GGME03
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the locations shown in the illustration.

    3. B001HHNE03

      Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.

      Tech Tips

      Tape the screwdriver tip before use.

    4. Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 front seatback board clips from the front seatback board sub-assembly LH.

      Text in Illustration
      *1 Protective Tape
      *a Point (A)

      Note

      Do not reuse the front seatback board clips after removing it.

    5. B001CK9

      Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.

  2. REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)


    1. B001DFV

      Remove the 2 front seatback board clips from the separate type front seatback spring assembly.

  3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    B001I7R

    1. Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.

  4. REMOVE RECLINING POWER SEAT SWITCH KNOB

    B001IEH

    1. Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.

  5. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. Disconnect the lifter motor connector.

    2. Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.

    3. Detach the clip of the front seat No. 1 inner cushion shield LH.

    4. Using a moulding remover, detach the 3 claws and guide.

    5. Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.

      B001CSW
    6. B001G2P

      Detach the 3 claws and open the wire harness cover.

    7. Detach the 3 wire harness clamps and disconnect the seat wire connector.

  6. REMOVE FRONT POWER SEAT SWITCH LH


    1. Remove the 3 screws.

    2. B001COW

      w/ Seat Memory System:

      Disconnect the 2 power seat switch connectors and remove the front power seat switch LH.

    3. B001GZA

      w/o Seat Memory System:

      Disconnect the power seat switch connector and remove the front power seat switch LH.

  7. REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)

    Click here

  8. REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

    B001FPA

    1. Detach the 2 claws and remove the front seat No. 1 inner cushion shield LH.

  9. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    B001ECH

    1. Using a moulding remover, detach the 3 claws and remove the front seat inner cushion shield LH.

  10. REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)

    B001ELK

    1. Using a moulding remover, detach the 4 claws and remove the front seat inner cushion shield RH.

  11. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH


    1. for Driver Side:

      Click here

    2. for Front Passenger Side:

      Click here

  12. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY


    1. w/o Seatback Board:


      1. B001DZC

        Disconnect the rubber band.

    2. B001DE4

      Detach the clamp and disconnect the No. 2 seat wire.

    3. B001GIF

      w/ Seat Heater System:

      Disconnect the seat heater connector and detach the seat heater wire harness clamp.

    4. B001FOZ

      Detach the 2 hooks.

    5. B001IF4E01
      Text in Illustration
      *1 Fastening Tape

      w/ Front Seat Side Airbag:


      1. Detach the claw and disconnect the airbag connector.

      2. Detach the 3 airbag wire harness clamps.

      3. Detach the fastening tape and open the cover.

      4. Disconnect the airbag wire harness.

    6. B001FWY

      Remove the 4 bolts and seatback assembly.

  13. REMOVE SEAT ADJUSTER COVER CAP

    B001EW8

    1. Remove the 2 seat adjuster cover caps.

  14. REMOVE FRONT SEAT LEG COVER LH

    B001I0J

    1. Detach the 2 claws.

    2. Move the front seat leg cover LH in the direction of the arrow to remove it.

  15. REMOVE SEAT CUSHION COVER WITH PAD


    1. B001E73

      w/ Seat Heater System:

      Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.

    2. Detach the hooks.

      B001FAK
    3. B001HD5

      for Front Passenger Side:

      Detach the claw and disconnect the connector.

    4. Remove the seat cushion cover with pad.

  16. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    1. B001CUA

      Type A:


      1. Remove the hog rings and disconnect the straps.

    2. B001I7CE01
      Text in Illustration
      *1 Tack Pin

      Type B:


      1. Cut off the tack pins and disconnect the straps.

    3. B001FTI

      Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.

  17. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)

    Click here

  18. REMOVE RECLINING ADJUSTER INSIDE COVER LH

    B001FR8

    1. Detach the claw and guide, and then remove the reclining adjuster inside cover LH.

  19. REMOVE FRONT SEAT LOWER CUSHION SHIELD LH

    B001E0D

    1. Remove the screw.

    2. Detach the hook and clip, and then remove the front seat lower cushion shield LH.

  20. REMOVE FRONT SEAT LOWER CUSHION SHIELD RH


    1. Remove the screw.

    2. Detach the hook and clip, and then remove the front seat lower cushion shield RH.

  21. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH

    B001HF0

    1. Remove the screw.

    2. Move the front seat cushion edge protector LH in the direction of the arrow to detach the hook and remove the front seat cushion edge protector LH.

  22. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH

    Tech Tips

    Use the same procedure described for the LH side.

  23. REMOVE SEAT CUSHION CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)


    1. B001IHA

      Detach the 2 clamps and 2 claws, and then remove the seat cushion climate control duct LH.

  24. REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)


    1. B001HEG

      Remove the 2 screws and seat cushion climate control bracket.

    2. Disconnect the connector.

    3. B001DR1

      Detach the 2 guides and remove the seat cushion climate control blower assembly LH as shown in the illustration.

  25. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)

    Click here

  26. REMOVE FRONT SEAT WIRE LH


    1. Remove the seat wire LH.

  27. REMOVE RECLINING ADJUSTER INSIDE COVER LH

    B001CLC

    1. Detach the guide and remove the reclining adjuster inside cover LH.

  28. REMOVE RECLINING ADJUSTER INSIDE COVER RH


    1. Detach the guide and remove the reclining adjuster inside cover RH.

  29. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    1. w/o Seatback Board:


      1. B001FB4

        Remove the 3 hog rings.

      2. Open the 2 fasteners, and then open the seatback cover.

        B001D85E01
        Text in Illustration
        *A for Cloth Seat *B for Leather Seat

    2. w/ Seatback Board:


      1. B001GB0

        Detach the hooks.

      2. B001GJE

        Remove the 5 hog rings.

    3. B001I0N

      w/ Front Seat Side Airbag:


      1. Remove the nut and seatback cover bracket from the seat frame.

      2. Disconnect the seatback cover bracket from the separate type front seatback pad.

    4. B001I6P

      Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.

    5. B001DXQ

      Remove the 13 hog rings and separate type front seatback cover.

  30. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)

    Click here

  31. REMOVE SEPARATE TYPE FRONT SEATBACK PAD


    1. Remove the separate type front seatback pad.

  32. REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)


    1. B001HLR

      Disconnect the connector.

    2. Remove the 4 screws and seatback climate control blower LH.

  33. REMOVE SEATBACK CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)


    1. B001EU6

      Detach the 2 claws and remove the seatback climate control duct LH.

  34. REMOVE NO. 2 SEAT WIRE


    1. for Driver Side:

      w/o Climate Control Seat System:


      1. B001GM5

        Disconnect the 2 connectors.

      2. Detach the 2 clamps and remove the No. 2 seat wire.

    2. for Driver Side:

      w/ Climate Control Seat System:


      1. B001CVA

        Disconnect the 2 connectors.

      2. Detach the 3 clamps and remove the No. 2 seat wire.

    3. for Front Passenger Side:


      1. Disconnect the connector.

      2. Detach the 2 clamps and remove the seat wire.

  35. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Front Seat Side Airbag)

    Click here