SEAT BELT CONTROL ECU REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   
   

   • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)

   Click here

3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

   Click here

4. REMOVE COWL SIDE TRIM BOARD LH (for LHD)

   Click here

5. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

   Click here

6. REMOVE INSTRUMENT SIDE PANEL LH (for LHD)

   Click here

7. REMOVE INSTRUMENT SIDE PANEL RH (for RHD)

   Click here

8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

   Click here

9. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

   Click here

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

11. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

12. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Click here

13. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

14. REMOVE SEAT BELT CONTROL ECU

    
    

    1. Disconnect the 2 connectors.

    2. 

       Text in Illustration

       *A	for LHD
       *B	for RHD

       Remove the bolt and remove the seat belt control ECU.