PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A47

DTC Code DTC Name
C1A47 Steering Angle Sensor

DESCRIPTION

The driving support ECU assembly receives steering angle information from the steering angle sensor (spiral with sensor cable sub-assembly). If the driving support ECU assembly detects a steering angle sensor (spiral with sensor cable sub-assembly) malfunction, DTC C1A47 will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A47 Steering Angle Sensor While the vehicle is being driven at a speed of 50 km/h (32 mph) or more, the driving support ECU assembly receives a steering angle sensor (spiral with sensor cable sub-assembly) malfunction signal continuously for 1 second or more.

  • Vehicle stability control system

  • Skid control ECU assembly (brake actuator assembly) (for 2TR-FE)

  • Skid control ECU assembly (master cylinder solenoid) (except 2TR-FE)

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • The pre-crash safety system uses the CAN communication system. First, confirm that there are no malfunction in the CAN communication system. Refer to How to Proceed with Troubleshooting.

    Click here

PROCEDURE


  1. CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)

    Tech Tips

    Pre-crash safety system DTC C1A47 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.


    1. Check for DTCs.

      for 2TR-FE: Click here

      except 2TR-FE: Click here

      Result
      Result Proceed to
      Vehicle stability control system DTCs are not output A
      Vehicle stability control system DTC are output (for 2TR-FE) B
      Vehicle stability control system DTC are output (except 2TR-FE) C

    B

    GO TO VEHICLE STABILITY CONTROL SYSTEM Click here

    C

    GO TO VEHICLE STABILITY CONTROL SYSTEM Click here

    A

  2. CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)


    1. Clear the DTCs.

      Click here

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here

      Result
      Result Proceed to
      DTC C1A47 is not output A
      DTC C1A47 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

  3. REPLACE DRIVING SUPPORT ECU ASSEMBLY


    1. Replace the driving support ECU assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)


    1. Clear the DTCs.

      Click here

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here

      Result
      Result Proceed to
      DTC C1A47 is not output A
      DTC C1A47 is output (for 2TR-FE) B
      DTC C1A47 is output (except 2TR-FE) C

    A

    END (DRIVING SUPPORT ECU ASSEMBLY WAS DEFECTIVE)

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    C

    REPLACE MASTER CYLINDER SOLENOID for LHD: Click here
    REPLACE MASTER CYLINDER SOLENOID for RHD: Click here