REAR AIRBAG SENSOR(for 3 Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR NO. 1 SEAT ASSEMBLY


    1. for 60/40 Split Double-folding Seat Type LH Side:


      1. Remove the rear No. 1 seat assembly Click here.

    2. for 60/40 Split Double-folding Seat Type RH Side:


      1. Remove the rear No. 1 seat assembly Click here.

    3. for 60/40 Split Tumble Seat Type LH Side:


      1. Remove the rear No. 1 seat assembly Click here.

    4. for 60/40 Split Tumble Seat Type RH Side:


      1. Remove the rear No. 1 seat assembly Click here.

    5. for 60/40 Split Slide Walk-in Seat Type LH Side:


      1. Remove the rear No. 1 seat assembly Click here.

    6. for 60/40 Split Slide Walk-in Seat Type RH Side:


      1. Remove the rear No. 1 seat assembly Click here.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    Click here

  4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  5. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  6. REMOVE MAT SET PLATE COVER

    Click here

  7. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  8. REMOVE QUARTER TRIM COVER HOLE LH

    Click here

  9. REMOVE REAR FLOOR CARPET ASSEMBLY

    Click here

  10. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  11. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

    Click here

  12. REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

    Click here

  13. REMOVE OUTER LAP BELT COVER

    Click here

  14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  15. REMOVE REAR AIRBAG SENSOR LH


    1. B001HGQ

      Remove the nut and rear airbag sensor.

    2. Disconnect the connector.