SIDE AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  7. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


    1. B001COT

      Disconnect the connector.

    2. Remove the bolt and side airbag sensor.