CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Install the airbag sensor with the 3 bolts.

      Torque:

      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note

      
      

      • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

   4. Check that the airbag sensor is not loose.

   5. Connect the connector.

2. INSTALL CONSOLE BOX ASSEMBLY

   
   

   1. for Automatic Transmission:

      
      

      1. Install the console box assembly Click here.

   2. for Manual Transmission:

      
      

      1. Install the console box assembly Click here.

   3. w/ Refrigerated Cool Box:

      
      

      1. Install the console box assembly Click here.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. CHECK SRS WARNING LIGHT

   
   

   1. Check the SRS warning light Click here.

5. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

   Click here