STEERING PAD INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL STEERING PAD


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Support the steering pad with one hand.

    4. B001FKHE01
      Text in Illustration
      *a Connector Lock

      Connect the airbag connector and lock the connector lock.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

      Tech Tips

      Use the same procedure to connect the airbag connector on the other side.

    5. Connect the horn connector.

    6. Set the steering pad to the steering wheel assembly.

    7. Check that the airbag wire harness and horn wire harness are not pinched.

    8. B001CMHE01
      Text in Illustration
      *a Upper Pin
      *b Lower Pin

      Press the steering pad with both hands to attach the upper pin to the torsion spring.

    9. Press the steering pad with both hands to attach the lower pin to the torsion spring.

      Note

      After installation, try to pull the steering pad and check that the steering pad is securely installed.

  2. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. Attach the 2 claws to install the cover.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. B001FM7E01
      Text in Illustration
      *A w/o Cruise Control System
      *B w/ Cruise Control System

      Attach the 2 claws to install the cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSPECT STEERING PAD


    1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

      Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

    2. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system.

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.