CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System) Combination Meter ECU Communication Stop Mode

DESCRIPTION

Detection Item Symptom Trouble Area
Combination Meter ECU Communication Stop Mode

Either condition is met:


  • "Combination Meter" is not displayed on "Bus Check".

  • "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies.


  • Power source or inside combination meter assembly

  • Combination meter assembly

WIRING DIAGRAM

A01XE7RE18
*1 from Battery
*2 GAUGE
*3 from IG2 Relay
*4 Combination Meter Assembly

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)


    1. A01XGS9E03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Combination Meter Assembly)

      Disconnect the G6 combination meter assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G6-21 (E2) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G6-26 (B) - Body ground Always 11 to 14 V
      G6-28 (IG+) - Body ground Ignition switch ON 11 to 14 V

    OK
    NG