GENERATOR INSPECTION

PROCEDURE


  1. INSPECT GENERATOR WITH CLUTCH PULLEY


    1. A01XF65

      Hold the center of the generator with clutch pulley and check that the outer ring turns counterclockwise and does not turn clockwise.

      Text in Illustration
      B001CHY Free
      B001DEF Lock

      If the result is not as specified, replace the generator with clutch pulley.

  2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    1. A01XIBPE19
      Text in Illustration
      *a Length

      Using a vernier caliper, measure the brush length.

      Standard exposed length
      9.5 to 11.5 mm (0.374 to 0.453 in.)
      Minimum exposed length
      4.5 mm (0.177 in.)

      If the brush length is less than the minimum, replace the generator brush holder assembly.

  3. INSPECT GENERATOR ROTOR ASSEMBLY


    1. A01XCTN

      Check that the generator rotor bearing is not rough or worn.

      If necessary, replace the generator rotor assembly.

    2. Check the generator rotor for an open circuit.


      1. A01XLISE55
        Text in Illustration
        *a Slip Ring

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        for 100 A (w/o Dual Air Conditioning System), 130 A Type:
        Tester Connection Condition Specified Condition
        Slip ring - Slip ring 20°C (68°F) 2.3 to 2.7 Ω
        for 100 A (w/ Dual Air Conditioning System) Type:
        Tester Connection Condition Specified Condition
        Slip ring - Slip ring 20°C (68°F) 3.4 to 3.8 Ω
        for 150 A Type:
        Tester Connection Condition Specified Condition
        Slip ring - Slip ring 20°C (68°F) 1.5 to 1.9 Ω

        If the result is not as specified, replace the generator rotor assembly.

    3. Check if the generator rotor is grounded.


      1. A01XCVLE48
        Text in Illustration
        *a Slip Ring
        *b Rotor Core

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Slip ring - Rotor core Always 10 MΩ or higher

        If the result is not as specified, replace the generator rotor assembly.

    4. A01XLI8E09
      Text in Illustration
      *a Diameter

      Using a vernier caliper, measure the slip ring diameter.

      Standard diameter
      14.2 to 14.8 mm (0.559 to 0.583 in.)
      Minimum diameter
      14.0 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.