BLIND SPOT MONITOR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL BLIND SPOT MONITOR SENSOR LH


    1. Connect the connector.

    2. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL BLIND SPOT MONITOR SENSOR RH


    1. Connect the connector.

    2. Install the blind spot monitor sensor RH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. INSTALL REAR BUMPER COVER

    Click here

  4. INSTALL REAR QUARTER PANEL MUDGUARD LH

    Click here

  5. INSTALL REAR QUARTER PANEL MUDGUARD RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. INSTALL NO. 1 REAR BUMPER PLATE

    Click here

  7. INSTALL BACK DOOR CHECK

    Click here

  8. INSTALL REAR BUMPER BAR PLATE

    Click here

  9. INSTALL JACK BOX HOLE COVER

    Click here

  10. INSTALL PINTLE HOOK ASSEMBLY (w/ Pintle Hook)

    Click here