BLIND SPOT MONITOR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

Tech Tips


  • The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.

  • The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector.

  • The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-2.2°) by using a jig, and that the sensor is 16 to 24° from the line parallel to the vehicle center line.

PROCEDURE


  1. INSTALL BLIND SPOT MONITOR SENSOR LH


    1. Connect the connector.

    2. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL BLIND SPOT MONITOR SENSOR RH


    1. Connect the connector.

    2. Install the blind spot monitor sensor RH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

    Click here

  4. INSTALL REAR BUMPER COVER

    Click here

  5. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

    Click here

    SST
    09870-60000   ( 09870-60010 )
    09870-60040

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here