TELEVISION CAMERA(for Side) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY

   
   

   1. Install the side television camera assembly with the 2 screws.

   2. Attach the clamp.

   3. Connect the connector.

   4. 

      *a

      Guide

      Attach the guide as shown in the illustration to attach the cover body to the support sub-assembly.

      Note

      Be careful not to break the guide.

   5. Attach the outer mirror body as shown in the illustration.

      

   6. Install the outer mirror body with the 5 screws.

   7. Using a T25 "TORX" socket wrench, install the cover base with 3 new "TORX" screws.

      Torque:

      3.8 N*m  { 39 kgf*cm, 34 in.*lbf }

      Note

      Make sure that the wire harness sub-assembly is not pinched between parts.

   8. Attach the 6 claws to install the lower mirror cover.

   9. 

      Attach the 5 claws to connect the outer rear view mirror gasket LH.

   10. Install the screw.

   11. 

       *a	Tape
       *b	Mark

       Align the marking of the wire harness sub-assembly with the end of the wire harness sub-assembly insertion hole on the outer rear view mirror gasket RH and secure it with vinyl tape as shown in the illustration.

       Note

       Apply the vinyl tape securely so there is no gap between the vinyl tape and cable.

   12. 

       *a	30 mm (1.18 in.)
       *b	50 mm (1.97 in.)

       Apply new vinyl tape in layers.

       Note

       Apply the tape securely so there is no gap between the vinyl tape and cable.

   13. 

       *a	Clamp
       *b	Tape
       *c	50 mm (1.97 in.)

       Secure the clamp using vinyl tape as shown in the illustration.

2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH

   Click here

3. INSTALL OUTER MIRROR COVER LH

   Click here

4. INSTALL OUTER REAR VIEW MIRROR GLASS

   Click here

5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

   Click here

6. ADJUST SIDE TELEVISION CAMERA ASSEMBLY

   Click here