ULTRASONIC SENSOR(for Front) INSPECTION

PROCEDURE

1. INSPECT FRONT CORNER ULTRASONIC SENSOR

   
   
   1. 

      *a	Component without harness connected (Front Corner Ultrasonic Sensor)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 1 (BI) - 5 (EI) Always 10 kΩ or higher 1 (BI) - 2 (BO) Always 10 kΩ or higher 3 (SI) - 4 (SO) Always Below 1 Ω 5 (EI) - 6 (EO) Always Below 1 Ω

      If the result is not as specified, replace the front corner ultrasonic sensor.

2. INSPECT FRONT CENTER ULTRASONIC SENSOR

   
   
   1. 

      *a	Component without harness connected (Front Center Ultrasonic Sensor)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 1 (BI) - 5 (EI) Always 10 kΩ or higher 1 (BI) - 2 (BO) Always 10 kΩ or higher 3 (SI) - 4 (SO) Always Below 1 Ω 5 (EI) - 6 (EO) Always Below 1 Ω

      If the result is not as specified, replace the front corner ultrasonic sensor.