CLEARANCE WARNING ECU(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for 4 Sensor Type)

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for 4 Sensor Type)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  4. REMOVE COWL SIDE TRIM BOARD RH (for 4 Sensor Type)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  5. REMOVE INSTRUMENT SIDE PANEL RH (for 4 Sensor Type)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  6. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for 4 Sensor Type)

    Click here

  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for 4 Sensor Type)

    Click here

  8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 4 Sensor Type)

    Click here

  9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for 4 Sensor Type)

    Click here

  10. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for 4 Sensor Type)

    Click here

  11. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (for 4 Sensor Type)


    1. except 5L-E:

      Click here

    2. for 5L-E:

      Click here

  12. REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)

    B001DQJ

    1. Disconnect the connector.

    2. Remove the bolt and clearance warning ECU assembly.

  13. REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for 8 Sensor Type)

    Click here

  14. REMOVE COWL SIDE TRIM BOARD LH (for 8 Sensor Type)

    Click here

  15. REMOVE INSTRUMENT SIDE PANEL LH (for 8 Sensor Type)

    Click here

  16. REMOVE INSTRUMENT PANEL ORNAMENT (for 8 Sensor Type)

    Click here

  17. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 8 Sensor Type)

    Click here

  18. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for 8 Sensor Type)

    Click here

  19. REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)

    B001IID

    1. Disconnect the connector.

    2. Remove the 2 nuts and clearance warning ECU assembly.