CLEARANCE WARNING ECU(for LHD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)


    1. Install the clearance warning ECU assembly with the bolt.

    2. Connect the connector.

  2. INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)


    1. Install the clearance warning ECU assembly with the 2 nuts.

    2. Connect the connector.

  3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. INSTALL INSTRUMENT PANEL ORNAMENT

    Click here

  6. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  7. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  8. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. CHECK SRS WARNING LIGHT

    Click here.