CLEARANCE WARNING ECU(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Click here

  4. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  5. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  6. REMOVE INSTRUMENT PANEL ORNAMENT

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  9. REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)

    B001FFJ

    1. Disconnect the connector.

    2. Remove the bolt and clearance warning ECU assembly.

  10. REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)

    B001FF5

    1. Disconnect the connector.

    2. Remove the 2 nuts and clearance warning ECU assembly.