MULTI-TERRAIN MONITOR SYSTEM, Diagnostic DTC:C1626
| DTC Code | DTC Name |
|---|---|
| C1626 | Steering Angle Sensor Failure |
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1626 | A fail flag is transmitted from the steering angle sensor. |
|
CAUTION / NOTICE / HINT
Note
-
When "!" mark is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
-
*1: for Navigation Receiver Type
-
*2: for Radio and Display Type
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed Click here.
-
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags.
Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System
-
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
PROCEDURE
-
REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
-
Replace the spiral with sensor cable sub-assembly Click here.
NEXT 
-
-
CHECK FOR DTC
-
Clear the DTCs Click here.
-
Check for DTCs Click here.
OK DTC C1626 is not output.
OK 
END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY IS DEFECTIVE)
NG
REPLACE PARKING ASSIST ECU for LHD: REPLACE PARKING ASSIST ECU Click here
REPLACE PARKING ASSIST ECU for RHD: REPLACE PARKING ASSIST ECU Click here -