MULTI-TERRAIN MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the multi-terrain monitor system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the engine switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to
      CAN DTC is not output (for Navigation Receiver Type) A
      CAN DTC is not output (for Radio and Display Type) B
      CAN DTC is output C

    B

    CHECK AUDIO AND VISUAL SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  4. CHECK NAVIGATION SYSTEM


    1. Refer to the navigation system (for Navigation Receiver Type).

      Click here

      Result
      Result Proceed to
      Navigation System (for Navigation Receiver Type) is normal A
      Navigation System (for Navigation Receiver Type) is abnormal. B

    A

    GO TO STEP 6 Click here

    B

    GO TO NAVIGATION SYSTEM Click here

  5. CHECK AUDIO AND VISUAL SYSTEM


    1. Refer to the audio and visual system (for Radio and Display Type).

      Click here

      Result
      Result Proceed to
      Audio and visual system (for Radio and Display Type) is normal A
      Audio and visual system (for Radio and Display Type) is abnormal. B

    B

    GO TO AUDIO AND VISUAL SYSTEM Click here

    A

  6. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTC.

      Click here

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

    B

    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    A

  8. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test.

      Click here

    2. Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  9. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  10. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END