BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AB1

DTC Code DTC Name
C1AB1 Short to +B in Outer Mirror Indicator(Slave)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a +B short in the blind spot monitor indicator RH.

DTC Code DTC Detection Condition Trouble Area
C1AB1 With the blind spot monitor main switch assembly (multi-function switch) on, the voltage applied to the indicator is high for a certain amount of time even though the blind spot monitor sensor is not outputting voltage to the indicator.

  • Harness or connector

  • Blind spot monitor sensor RH

  • Outer rear view mirror assembly RH

  • Outer rear view mirror sub-assembly RH

WIRING DIAGRAM

A01XI4GE53

CAUTION / NOTICE / HINT

Note

When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR RH CIRCUIT)


    1. Disconnect the R43 blind spot monitor sensor RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      R43-4 (OMIR) - Body ground Engine switch on (IG) Below 1 V

    OK

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)


    1. Disconnect the R43 blind spot monitor sensor RH connector.

    2. Disconnect the J3 outer rear view mirror assembly RH connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      R43-4 (OMIR) - Body ground Engine switch on (IG) Below 1 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH)


    1. Disconnect the R43 blind spot monitor sensor RH connector.

    2. Disconnect the outer rear view mirror sub-assembly RH connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      R43-4 (OMIR) - Body ground Engine switch on (IG) Below 1 V

    OK

    REPLACE OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH Click here

    NG

    REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH Click here