PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU), Diagnostic DTC:C1625

DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates a power supply problem.

DTC Code DTC Detection Condition Trouble Area
C1625 Open or short in spiral with sensor cable sub-assembly power source

  • Harness or connector

  • Spiral with sensor cable sub-assembly

WIRING DIAGRAM

B001EXCE85

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following procedure.

  • When "System initializing" is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.


    • *1: for Navigation Receiver Type

    • *2: for Radio and Display Type

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

  • The parking assist monitor system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the parking assist monitor system after confirming that the communication system is functioning properly Click here.

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    1. B001IDQE03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Spiral with Sensor Cable Sub-assembly)

      Disconnect the G33 spiral with sensor cable sub-assembly connector Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G33-2 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      G33-5 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      G33-6 (BAT) - Body ground Always 11 to 14 V

    OK

    REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR