PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) DTC CHECK / CLEAR


  1. CHECK DTC (USING GTS)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.

    5. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

    6. Check for DTCs Click here.

      Note

      The navigation receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

      System Proceed to
      Navigation System

      Click here

  2. CLEAR DTC (USING GTS)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.

    5. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

    6. Clear the DTCs.

  3. CHECK DTC (USING DIAGNOSTIC MODE)


    1. Refer to navigation system Click here.

  4. CLEAR DTC (USING DIAGNOSTIC MODE)


    1. Refer to navigation system Click here.