TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display) Taillight Relay Circuit

WIRING DIAGRAM

B001DBPE04
*1 from PANEL Relay
*2 Clearance Warning ECU

PROCEDURE


  1. CHECK TAILLIGHT


    1. Turn the light control switch to the TAIL position.

    2. Check that the taillight turns on.

      OK
      Taillight turns on.

    NG

    GO TO LIGHTING SYSTEM Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)


    1. A01XLZOE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Clearance Warning ECU)

      Disconnect the I1 clearance warning ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      I1-11 (TL) - Body ground Ignition switch ON, light control switch TAIL 7 V or higher
      Ignition switch ON, light control switch not TAIL Below 1.5 V

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR