NAVIGATION RECEIVER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  4. REMOVE NAVIGATION RECEIVER ASSEMBLY


    1. A01XHGT

      Remove the 4 bolts.

    2. A01XHIG

      Pull the navigation receiver assembly to detach the 7 clips on the backside of the navigation receiver assembly.

    3. Disconnect each connector and remove the navigation receiver assembly.

  5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

    Click here

  6. REMOVE HAZARD SWITCH WIRE


    1. A01XHS9

      Detach the clamp and remove the hazard switch wire.

  7. REMOVE NO. 1 RADIO RECEIVER BRACKET


    1. A01XMOD

      Remove the 3 screws and No. 1 radio receiver bracket.

  8. REMOVE NO. 2 RADIO RECEIVER BRACKET


    1. A01XHY2

      Remove the 3 screws and No. 2 radio receiver bracket.

  9. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01XCLS

      Detach the 7 claws, 2 guides and remove the No. 3 instrument panel register assembly.