NAVIGATION SYSTEM(for Radio and Display Type) Data Signal Circuit between Stereo Jack Adapter and Extension Module

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation ECU via this circuit.

WIRING DIAGRAM

B001DLBE22

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the A navigation ECU connector.

    2. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-2 (US1-) - H68-2 (US1-) Always Below 1 Ω
      A-3 (US1+) - H68-3 (US1+) Always Below 1 Ω
      A-2 (US1-) - Body ground Always 10 kΩ or higher
      A-3 (US1+) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR