INSTRUMENT PANEL SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH

    Click here

  4. REMOVE NO. 1 ASSIST GRIP

    Click here

  5. REMOVE FRONT PILLAR GARNISH LH

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

    Click here

  7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. B001IF1

      Remove the 2 screws.

    2. Disconnect the connector and remove the front No. 2 speaker assembly.

      Note

      Do not touch the cone of the speaker.

  8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)

    Click here

  9. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  10. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY


    1. B001HTFC01
      B001CHY Screw
      B001DEF Connector

      Remove the 2 screws.

    2. Disconnect the connector and remove the front No. 4 speaker assembly.

      Note

      Do not touch the cone of the speaker.