RADIO RECEIVER(for Radio and Display Type) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  2. INSTALL NO. 2 RADIO RECEIVER BRACKET


    1. Install the No. 2 radio receiver bracket with the 3 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  3. INSTALL NO. 1 RADIO RECEIVER BRACKET


    1. Install the No. 1 radio receiver bracket with the 3 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  4. INSTALL NAVIGATION ECU (w/ Navigation System)

    Click here

  5. INSTALL HAZARD SWITCH WIRE

    Click here

  6. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY

    Click here

  7. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY


    1. Connect each connector.

    2. A01XK7Z

      Insert the radio and display receiver assembly and attach the 7 clips on the backside of the radio and display receiver assembly.

      Note

      When inserting the receiver, do not press the knobs on it.

    3. Install the radio and display receiver assembly with the 4 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  8. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.