STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) INSTALLATION

PROCEDURE

1. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

   Click here

2. INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

   Click here

3. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

   Click here

4. INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

   Click here

5. INSTALL STEERING COLUMN ASSEMBLY (TILT STEERING GEAR ASSEMBLY WITH MOTOR)

   
   

   1. Align the matchmarks on the steering intermediate shaft, steering shaft stopper and steering column.

   2. Install the steering column with the 4 nuts.

      Torque:

      26 N*m  { 265 kgf*cm, 19 ft.*lbf }

   3. Install the bolts.

      Torque:

      36 N*m  { 367 kgf*cm, 27 ft.*lbf }

   4. Attach the claws to install the wire harness protector and wire harness.

6. INSTALL NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY

   Click here

7. INSTALL INSTRUMENT LOWER PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

8. INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

   
   

   1. Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.

   2. Connect the connectors to the combination switch with spiral cable.

9. INSTALL TILT AND TELESCOPIC SWITCH

   
   

   1. Attach the claw to install the switch.

   2. Connect the switch connector.

10. INSTALL STEERING COLUMN UPPER COVER

    
    

    1. Attach the claw to install the steering column upper cover.

    2. Attach the 4 clips to install the steering column upper cover to the instrument cluster finish panel.

11. INSTALL STEERING COLUMN LOWER COVER

    
    

    1. Attach the 2 claws to install the steering column lower cover.

       Note

       Do not damage the tilt and telescopic switch.

    2. Install the 3 screws.

12. ADJUST SPIRAL CABLE SUB-ASSEMBLY

    Click here

13. INSTALL STEERING WHEEL ASSEMBLY

    Click here

14. INSTALL FRONT WHEEL LH

15. CHECK FRONT WHEELS FACING STRAIGHT AHEAD

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    
    

    • Reset the auto tilt away function setting to the previous condition by changing the customize parameter Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

17. CHECK SRS WARNING LIGHT

    Click here