STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel Click here.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the auto tilt away function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the auto tilt away function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note


      • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL LH

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE STEERING COLUMN LOWER COVER


    1. B001HBQ

      Remove the 3 screws.

    2. Detach the 2 claws and remove the steering column lower cover.

      Note

      Do not damage the tilt and telescopic switch.

  6. REMOVE STEERING COLUMN UPPER COVER


    1. B001HRE

      Detach the 4 clips.

    2. Detach the claw and remove the steering column upper cover.

  7. REMOVE TILT AND TELESCOPIC SWITCH

    Click here

  8. REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY


    1. Disconnect the connectors from the combination switch with spiral cable.

    2. B001FOC

      Use pliers to hold the clamp and raise the claw with a screwdriver. Then remove the combination switch switch assembly with spiral cable sub-assembly from the steering column assembly.

  9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)

    Click here

  10. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

    Click here

  11. REMOVE STEERING COLUMN ASSEMBLY


    1. Disconnect the connectors.

    2. Detach the claws and remove the wire harness protector and wire harness.

    3. B001FI7E07
      Text in Illustration
      *a Matchmark

      Put matchmarks on the steering actuator and steering column.

    4. Remove the bolt.

    5. B001GWP

      Remove the 4 nuts, steering column and steering shaft stopper.

  12. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH

    Click here

  13. DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

    Click here

  14. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

    Click here

  15. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

    Click here