POWER STEERING ECU REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   
   

   • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

   Click here

3. REMOVE COWL SIDE TRIM BOARD RH

   Click here

4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

5. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

6. REMOVE INSTRUMENT PANEL ORNAMENT

   Click here

7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

   Click here

8. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

   Click here

9. REMOVE ECU INTEGRATION BOX RH

   Click here

10. REMOVE POWER STEERING ECU ASSEMBLY

    
    

    1. 

       Using a screwdriver, detach the 2 claws and remove the power steering ECU assembly.

       Tech Tips

       Tape the screwdriver tip before use.