VANE PUMP(for 1KD-FTV) REMOVAL

CAUTION / NOTICE / HINT

Note


  • When using a vise, do not overtighten it.

  • When installing the parts indicated by arrows, coat them with power steering fluid Click here.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT WHEEL RH

  3. REMOVE FRONT BUMPER LOWER COVER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  5. REMOVE REAR ENGINE UNDER COVER ASSEMBLY

    Click here

  6. REMOVE FRONT FENDER APRON SEAL LH


    1. Detach the 5 clips remove the apron seal.

  7. REMOVE NO. 1 FRONT FENDER APRON TO FRAME SEAL LH


    1. Detach the 5 clips remove the apron seal.

  8. REMOVE PRESSURE FEED TUBE ASSEMBLY


    1. B001IK6

      Disconnect the 2 connectors.

    2. B001F2A

      Remove the union bolt and disconnect the pressure feed tube from the vane pump.

    3. Remove the gasket from the pressure feed tube.

  9. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    1. B001DTO

      Remove the clamp and disconnect the hose.

  10. REMOVE VANE PUMP ASSEMBLY


    1. B001F4O

      Remove the 2 nuts and vane pump.

    2. Remove the O-ring.