VANE PUMP(for 1GR-FE) INSTALLATION

PROCEDURE

1. INSTALL VANE PUMP ASSEMBLY

   
   

   1. Install the vane pump with the 2 bolts.

      Torque:

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

   2. Install the wire harness bracket with the bolt.

      Torque:

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

2. CONNECT PRESSURE FEED TUBE

   
   

   1. Install a new gasket to the pressure feed tube.

   2. Connect the pressure feed tube and install the union bolt.

      Torque:

      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

      Tech Tips

      Make sure the stopper of the pressure feed tube touches the vane pump.

3. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

   
   

   1. Connect the No. 1 oil reservoir to pump hose to the vane pump assembly with the clip.

4. CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

   
   

   1. Connect the 2 connectors.

5. INSTALL FAN AND GENERATOR V BELT

   Click here

6. INSTALL AIR CLEANER CASE

7. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

8. INSTALL AIR CLEANER CAP AND HOSE

   Click here

9. INSTALL V-BANK COVER

   Click here

10. INSTALL FRONT FENDER APRON SEAL RH

    Click here

11. INSTALL FRONT WHEEL RH

    Torque:

    for steel wheel

    112 N*m  { 1137 kgf*cm, 82 ft.*lbf }

    for aluminum wheel

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. ADD POWER STEERING FLUID

14. BLEED POWER STEERING FLUID

    Click here

15. INSPECT FOR POWER STEERING FLUID LEAK