VANE PUMP(for 1GR-FE) INSPECTION

PROCEDURE


  1. INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING


    1. A01XIXBE11
      Text in Illustration
      *a Outer Diameter
      *b Inner Diameter

      Using a micrometer, measure the outer diameter of the vane pump shaft.

    2. Using a vernier caliper, measure the inner diameter of the vane pump front housing bush.

    3. Calculate the oil clearance.

      Oil clearance = Inner diameter of the bush - Outer diameter of the shaft

      Maximum oil clearance
      0.07 mm (0.00276 in.)

      If the oil clearance is more than the maximum, replace the vane pump assembly.

  2. INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE


    1. A01XG48E11

      Using a micrometer, measure the thickness of the vane pump plates.

      Standard thickness
      1.405 to 1.411 mm (0.0554 to 0.0555 in.)
      Text in Illustration
      *a Thickness

      If the thickness is not as specified, replace the vane pump assembly.

    2. A01XL8WE02

      Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plate.

      Maximum clearance
      0.025 mm (0.00098 in.)
      Text in Illustration
      *1 Feeler Gauge

      If the clearance is more than the maximum, replace the vane pump assembly.

  3. INSPECT PRESSURE PORT UNION

    If the union seat in the pressure port union is severely damaged, it may cause fluid leakage. In that case, replace the vane pump assembly.