REAR BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DRAIN BRAKE FLUID

    Note

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  3. REMOVE REAR FLEXIBLE HOSE LH


    1. A01XCY3

      Remove the union bolt, gasket and rear flexible hose from the rear disc brake cylinder.

    2. A01XCY5

      Disconnect the brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

    3. Remove the clip.

  4. REMOVE REAR FLEXIBLE HOSE


    1. A01XED1

      Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

    2. Remove the 2 clips.

    3. Remove the rear flexible hose.

    4. A01XH8K

      Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

    5. Remove the 2 clips.

    6. Remove the rear flexible hose.

  5. REMOVE NO. 5 FLEXIBLE HOSE BRACKET


    1. for 3 Door:


      1. A01XKN3

        Remove the bolt and bracket from the upper arm bracket.

    2. for 5 Door:


      1. A01XLWG

        Remove the bolt and bracket from the upper arm bracket.

  6. REMOVE NO. 6 FLEXIBLE HOSE BRACKET


    1. Remove the bolt and bracket from the rear axle housing.